×

Warning

JFolder::create: Could not create folder.Path: /home/agus1975/watermart.co.id
Key folder in safepath unaccessible

Cartridge Osmonic Putrex

Print
The Purtrex depth filter is an exceptional value for general applications where long life, high purity and low change-out frequency are required. Produced through GE Water & Process Technologies’ patented melt blown microfiber technology,Purtrex is a 100% pure polypropylene depth filter with exceptional dirt-holding capacity.
Description

Description and Use
The Purtrex depth filter is an exceptional value for general applications where long life, high purity and low change-out frequency are required. Produced through GE Water & Process Technologies’ patented melt blown microfiber technology,Purtrex is a 100% pure polypropylene depth filter with exceptional dirt-holding capacity.Purtrex’ true-graded density filter matrix (lower density at the surface of the filter with progressively higher density toward the center) captures particles throughout the entire filter depth. This translates to longer life and fewer change-outs than existing string-wound or resin-bonded filters. Purtrex contains no wetting agents, solvents, anti- static agents or binders, and meets the requirements of the FDA for food and beverage contact. The filter incinerates to trace ash for easy disposal.

Typical Applications

 

  • Potable water filtration
  • Chemical filtration - wide chemical compatibility
  • Plating baths
  • Amine Filtration
  • Meets FDA compliance for food and beverage contact

 

General Properties

 

Purtrex filters are available the following absolute pore size micron ratings: 1, 3, 5, 10, 20, 30, 50 and 75 microns.

 

Type Micron Rating Nominal Cartridge Length End #1 Adapter End #2 Adapter Elastomer Material
PX

01 = 1 μm

05 = 5 μm

10 = 10 μm

20 = 20 μm

30 = 30 μm

50 = 50 μm

75= 75 μm

9 3/4 in (24.8 cm)

9 7/8 in (25.1 cm)

10 in (25.4 cm)

19 1/2 in (49.5 cm)

20 in (50.8 cm)

29 1/4 in (74.3 cm)

30 in (76 cm)

40 in (102 cm)

50 in (127 cm)

Y = 1 inch (25.4 cm) Open End Gasket

L = Extended Core

E = 222 O-Ring

X = Standard Plain End

Y = 1 inch (25.4 cm) Open End Gasket

K = Self Seal Spring

H = Fin Adapter

S = Solid End

Gasket

P = Santoprene2 (Gasket Only)

O-Rings

S = Silicone

E = EPDM